PREORDER-Should be sending out early October
This BrewZilla Polycarbonate Sight Glass comes assembled with stepless clamps.
To remove your stainless steel sight glass, start by removing the two screws that mount the top section of the re-circulation tube.
Then using a spanner *not included* loosen and remove the bottom 1/2" female fitting. There is a small white washer underneath. Move that to the side as we'll need that later for the upgrade!
Swap over the camlock fitting
Please note you may need to use varying amounts of thread tape to get it to seal in the right position once it has been tightened back down on the female bottom end.
The sight glass itself is not made from glass, it is made from robust polycarbonate.
- Stainless ½ inch Male BSP threaded post with orings
- Stainless ½ inch Female BSP threaded post with orings
- 36cm long polycarbonate tube (13mm ID x 15mm OD)
The stepless clamps used are 14-16mm.