We have been converting pots into homebrew vessels since we first started in 2013 and the range of taps and fittings has grown to meet requirements for HLTs, mash tuns and boil kettles custom built to customer requirements
Many of our stainless steel fittings come from a UK stainless steel fittings supplier who are experts in their field and have very high quality standards
If you don't find what you are looking for, get in touch and we can probably get it for you
With a focus on quality reliable pumps, a good offering of pumps used in homebrewing applications whether looking for 240 AC or DC pumps
All the pumps are magnetic drive so have high reliability and no need for a seal between the wet side pump head and dry side pump motor. This is a common point of failure of shaft drive pumps which is not an issue for the more reliable magnetic drive pumps
High quality hose and typical fittings for pump connection also included in this category
4L PET Oxebar Keg with Cap and Handle (PCO38). Keg with cap and handle only, other products in images illustrating usage are available as separate options
Keep your oxygen-sensitive beverages fresher for longer with the Oxebar Monolayer. We recommend this product for storing beer up to 3-6 months.
The new lightweight and reusable plastic kegs are brought to you by Oxebar and KegLand. Store your homebrew in a more convenient size, take it away camping or to a bbq. The new shorter profile 4L under 330mm will fit in most esky coolers. You can also dispense with it lying on its side.
Do not Exceed 4 Bar / 58psi or 45°C
This great value re-usable plastic keg is the best way to store your home brew in a smaller sized container than traditional 19L corny kegs. The small 4L size is convenient, light weight and perfect for sharing beverages with friends.
This 4L keg is light weight, compact and has extreme oxygen barrier properties. This extremely low gas transmission means your beverage will stay much fresher for longer. Even if you do consume the beverage in a short time, that short time will have much less oxygen transmission compared to other PET kegs on the market. Suitable for carbonated and non-carbonated beverages.
his product is sold with the PCO38 cap however if you would like to dispense this product through a draft system we recommend the use of the PCO38 Tapping Head (KL20169). The tapping head is sold separately and allows you to attach standard ball lock disconnects and add a pressure relief valve to the top of this keg design.
What is Oxebar Mono
Oxebar Mono is a PET polymer blend that utilises several polymers blended together to significantly improve gas barrier properties. When compared with standard PET plastic Oxebar Mono is able to reduce oxygen ingress and CO2 loss so your precious beverage is preserved and shelf life extended by x3. We recommend this product for beer stored in keg up to 6 months.
Do not Exceed 4 Bar / 58psi or 45°C
Periodic Hydrotesting Requirement
All pressure vessels should be hydrotested periodically. This is a very simple process and it's nothing to be feared. We recommend that this container be pressure tested every 2 years up to 6 bar. The instructions for this are:
Remove RED prv and fit GREY prv (you can borrow one of these from a 19L keg.
Fill keg to the absolute brim with water. DO NOT forget this step.
Use bike pump, CO2 regulator, air compressor or any other pressure source to pressurize the keg to 6 bar.
Hold the keg at 6 bar for 1 minute
Release the pressure and immediately remove GREY prv and swap back to RED prv.
Note: This test should be done with the keg and water in the keg at room temperature 15-30C