shop by category

Home

left banner

The following instructions describe the disassembly of the 2 piece ball valve to enable thorough cleaning.

While this is not required after every use, it should be done periodically, say every few months or every 4 brews or so.

1. Unscrew Ball Valve

Holding fixed side of 2 piece ball value with wrench (right on picture) use a second wrench to unscrew the ball valve (left on picture).

Once loosened the ball valve end cap should just unscrew by hand.

 
2. Separate Ball Valve

Picture shows the separated 2 piece ball valve.

The ball part of the valve has a slot at the top which engages with a slot that turns with the ball valve handle.

Be careful not to damage the white seals.

 
3. Remove Ball and Clean Valve

Holding fixed side of 2 piece ball value with wrench (right on picture) use a second wrench to unscrew the ball valve (left on picture).

Once loosened the ball valve end cap should just unscrew by hand.

Disclaimer: While the content aim to be clear and complete, any damage occurring through customers using these instructions are the responsibility of the customer